Mazda CX-3 Owner's Manual page 180

When Driving
Instrument Cluster and Display
Signal
Cruise Main Indication
*
(White)
Cruise Set Indication/Indicator Light
*
(White/Green)
*1 The light turns on when the ignition is switched on for an operation check, and turns off a few seconds later or
when the engine is started. If the light does not turn on or remains turned on, have the vehicle inspected at an
expert repairer, we recommend an Authorised Mazda Repairer.
Wrench Indicator Light
When the ignition is switched ON, the
wrench indicator light turns on and then
turns off after a few seconds.
The wrench indicator light turns on
when the preset maintenance period
arrives. Verify the content and perform
maintenance.
Refer to Maintenance Monitor on page
6-14 .
SKYACTIV-D 1.5
The wrench indicator light turns on under
the following conditions:
The engine oil has deteriorated.
      
The engine oil level is around the MIN
      
mark on the dipstick or it is less than the
MIN mark.
*
The engine oil level is around the X
      
mark on the dipstick or it exceeds the X
mark.
*
4–42
*Some models.
Indicator Lights
Check the engine oil. Refer to Inspecting
Engine Oil Level on page 6-26 .
Replace the engine oil if the wrench
indicator light does not turn off even
though the engine oil level is in the normal
range.
NOTE
Depending on the vehicle use
   
conditions, the wrench indicator light
may turn on for reasons other than
the preset maintenance period.
Whenever the engine oil is replaced,
   
a reset of the vehicle engine control
unit is necessary.
Your Authorised Mazda Repairer

will be able to reset the engine
control unit or see page 6-25 for
the Vehicle engine control unit reset
procedure.
Page
4-194
4-194