Page 1
For Dismantler M Hybrid Battery Disposal Manual Target Model MAZDA 3 MAZDA CX-30 Mazda Motor Corporation Customer Service Div,Recycle Promotion Gr. Issued(Ver.1.1) 2021/03 Information in this manual is subject to change without notice.
Contents 1. Intoroduction 2. Overview for M Hybrid Battery 3. Hndling for M Hybrid Battery 4. Recommendaiton for safe collection of M Hybrid Battery 5. Removed M Hybrid Battery 6. Storage for removed M Hybrid Battery...
1. Intoroduction Some vehicles manufactured by Mazda Motor Corporation is mounted an M Hybrid Battery. This manual describes how to remove the battery from the End-of Life Vehicle(ELV). Read this manual carefully and observe the precautions before handling the battery.
3. Handling for M Hybrid Battery Introduction ● • There is no danger if the battery is not deformed, leaking or generating heat. • The electrolyte for the battery is strongly acidic. If the electrolyte leaks out and breathes vapor, or gets into your eyes, skin, etc, take the following first aid measures.
Mazda cannot be held liable for any accidents / damages caused by diversion / modification / disassembly of theM hybrid batteries, or any accidents / damages caused after neglect / discard / resale / transfer.
Otherwise, it could be damaged. ー Terminal cover 1) Switch the ignition OFF. 2) Disconnect the negative battery terminal and wait for 1 min or more. 3) Lift up the vehicle. 4) Disconnect the ground plate. ⑴ Remove the following parts. ー Tunnel cover ー...
Page 7
⑵ Open the terminal cover(negative side) ⑶ Remove the nut and bolt shown in the figure and remove the ground plate. • Installing a ground plate with a failed battery (stuck internal relay) can cause a short circuit. Remove and store the ground plate from the battery. ⑷...
Page 8
⑹ Close the terminal cover (negative side). ⑺ Remove the nut shown in the figure and disconnect the positive terminal. ⑻ Close the terminal cover using the following procedure. ➀ Open the terminal cover (negative side). ➁ Close the terminal cover (positive side). ➂...
Page 9
5) Remove the following parts. ➀ Brace bar ➁ Tunnel member ➁ ➀ 6) Disconnect the connector. 7) Remove in the reverse order of removal. ➀ ➂ ➃ ➁ ➄ ➀ M Hybrid Battery component ➁ Bracket No.1 ➂ Short-cord ➃...
6. Storage for removed M Hybrid Battery 1) To ensure the safety of the storage and transportation of the removed M Hybrid Battery, be sure to take measures to prevent short circuits. • Protect the terminal cover(positive side and negative side) with insulating tape (such as vinyl tape). •...