Installing An Optional Tape Drive In The Redesigned Left-Side Drive Tray; Replacing The Drive Tray Assembly In The System; Figure 3-21 Installing A Tape Drive In The Redesigned Left-Side Drive Tray - Digital Equipment AlphaStation 500 Series User Information

Installing System Options

Installing an Optional Tape Drive in the Redesigned Left-Side Drive Tray

1. Insert the optional tape drive into position in the drive tray as shown in Figure 3-21.
2. Secure with the four mounting screws.
3. Connect SCSI and power cables.

Figure 3-21 Installing a Tape Drive in the Redesigned Left-side Drive Tray

Replacing the Drive Tray Assembly in the System

To replace the drive tray assembly in the system, follow this procedure:
1. Reconnect the SCSI and power cables to the drives.
2. Replace the drive tray assembly in the system unit by sliding it forward until it is
properly positioned. Ensure that the two mounting tabs on the drive tray assembly
engage the mounting finger and slot in the system unit.
3. Push bracket forward until tabs lock tray in place.
4. Replace and lock the top cover, as described at the end of this chapter.
5. Connect the power cord and plug it into the wall outlet.
3-30 AlphaStation 500 Series User Information
MLO-013735