3–30 FRU Replacement
3.2.14 Floppy Drive Replacement
Replace the floppy drive as follows (Figure 3–17):
1. Remove the cover (Section 3.2.4) and open the system unit
(Section 3.2.5).
2. Remove the ribbon cable from the back of the drive.
3. Remove the three mounting screws that hold the drive in
place. One screw is located underneath the left side and two
are on the right side of the floppy.
4. Remove the floppy disk drive.
5. Set the switch on the new drive to match that of the old drive.
6. Install the new drive and re-install the three mounting screws
7. Reconnect the ribbon cable to the floppy drive.
8. After replacing the drive reconnect all system cables.
9. Verify the operation of the new drive.
10. Reinstall the system cover.
3.2.15 Replacing An Optional Floppy Drive
To remove or replace an optional floppy disk drive, refer to the
appropriate option installation guide.
3.2.16 Replacing an Optional Hard Disk or Tape Drive
To remove or replace an optional hard disk or tape drive, refer to
the appropriate option installation guide.