Technical Specifications
System Board Jumper Locations
Jumper pins allow you to set specific system parameters. Set them by changing the pin
location of jumper blocks. A jumper block is a small plastic-encased conductor (shorting
plug) that slips over the pins. To change a jumper setting, remove the jumper from its
current location with your fingers or small needlenose pliers. Place the jumper over the
two pins designated for the desired setting. Press the jumper evenly onto the pins. Be
careful not to bend the pins.
Figure C-1 shows the locations of the system board jumper pins. Table C-12 lists the
system board jumpers and factory-default settings.
________________________ CAUTION __________________________
Do not touch any electronic component unless you are safely grounded. Wear a
grounded wrist strap or touch an exposed metal part of the system unit chassis.
A static discharge from your fingers can result in permanent damage to
electronic components
___________________________________________________________
C-10 AlphaStation 500 Series User Information