Table of Contents
Advertisement
6-2-2 Separation Roller
1. Remove the document tray and copy tray.
2. Remove cover (A) — 2 screws.
3. Open the ADF cover.
4. Remove ground wire (B) — 1 screw.
5. Open the upper unit.
6. Disconnect hinge (C) – 1 screw.
7. Remove the ADF cover (D) — 1 screw.
8. Remove the upper document guide plate (E) from the ADF
covver — 5 screws (F).
Caution:
Do not lose the ground wire.
9. Remove the two screws holding the separation roller
bracket (G).
10. Take out the separation roller (H).
Take care not to lose the spring (I) at the front end.
11. Remove the separation roller (2 screws).
When replacing:
• The spring (I) at the front end of the separation roller
must be fit into the circular depression (J) on the
separation roller shaft bracket.
• The two springs (K) on the upper document guide
plate must be fit into their respective circular de-
pressions (L) on the ADF cover.
• Do not touch the rubber surface of the new roller, or
paper feed errors will develop sooner than normal.
6 - 6
Advertisement
Table of Contents
