Table of Contents
Advertisement
6-10-4 FCU
1. Remove the MIF, MBU, Modem, BSR, and PMU (see sec-
tions 6-10-1 and 6-10-2).
CAUTION: Make sure that you do not accidentally flick
off the jumper from the MBU or BSR battery
switches (SW1 on each PCB).
Remove the FCU — 16 connectors (not including the
2.
OPU and monitor speaker), 5 screws.
After replacing the FCU do the following:
1.
Adjust the standby level of the video signal.
2.
Carry out the quality checks stated in section 5-4.
3.
Enter the date and time.
6 - 32
Advertisement
Table of Contents
