Ricoh 1000L Field Service Manual page 118

6-8-6 Hot Roller Strippers
It is advisable to replace all five as a set.
There is no need to remove the fusing unit.
1. Remove the lower copy exit cover (A) — 2 screws.
2. Open the exit assembly.
3. Remove the lower copy exit guide plate (B) – 2 screws.
4. Remove the upper copy exit cover (C) — 3 screws.
5. Close the exit assembly and remove the antistatic brush
and holder (D) — 2 screws.
6. Open the exit assembly.
7. Move the upper copy exit guide plate (E) out of the way.
8. Unhook the springs from the hot roller strippers.
9. Take out the hot roller strippers (F) – push down on the
holding bar (G) while taking them out.
Reinstalling:
• The bristles on the antistatic brush should be pointing
down. Also make sure that the three indentations in
the top of the antistatic brush match the positions of
the screw holes for the upper copy exit cover.
• Lower copy exit cover — the clip on the center of the
right side of the fusing unit (as viewed from the front of
the machine) must clip onto the cover before the cover
is screwed in.
6 - 27