Using Dump Mode In Ipl - Intermec PB51 User Manual

Printable characters are printed in black-on-white. Control characters
and space characters (ASCII 000 to 032 dec) are printed in white-on-
black.
As long as a continuous string of characters is bei ng received, the
program wraps the lines until the label is full and then starts to print
another label. After each character transmission, t he following
information prints:
When you exit Dump mode, a nal label prints to in form you that it is
exiting from Dump mode.

Using Dump Mode in IPL

When you enter Dump mode, the printer captures inco ming
characters on the communication ports and prints th em on one or
more labels.
If you have IPL rmware on your printer, you can a ccess Dump mode
in two di erent ways with slightly di erent resul ts:
To enter Dump mode using the control panel buttons
The printer feeds out several labels (or inches of media), prints the test
labels, and then enters Dump mode.
To exit Dump mode using the control panel buttons
PB51 Mobile Label and Receipt Printer User's Guide
Chapter 3 — Troubleshooting and Maintaining the PB5 1
Page number
Number of characters printed on the label
Total number of characters received so far
You can access Dump mode through Test mode or Exten ded Test
mode and you will receive printouts that look exactly like those
produced with the Line Analyzer program in Fingerpr int. For
more information, see the previous procedure,
Analyzer in Fingerprint" on page 46
You can access Dump mode using the control panel buttons. If
you access Dump mode this way, characters are printed on a
continuous line along with corresponding hexadecimal numbers.
Press and hold the Feed and Standby buttons until the printer
starts feeding out media.
Press the Feed button.
"Using the Line
.
47