Intermec PB51 User Manual page 40

Chapter 2 — Con guring the PB51
4 From the host PC, check the wireless settings.
5 Set up the PB51 to use the correct SSID and authentication
6 If you are going to use certi cates for validation , transfer the
7 Verify that the PB51 is connected to the access point and make
Understanding the 802.11 Radio Icons
Icon
30
If you have an IPL version of the printer, send the se commands to
the PB51:
<STX><SI>wt,SSID<ETX>
<STX><SI>wt,WEP1<ETX>
<STX><SI>wt,WEP2<ETX>
<STX><SI>wt,WEP3<ETX>
<STX><SI>wt,WEP4<ETX>
<STX><SI>wt,AUTH<ETX>
<STX><SI>wt,WPA<ETX>
<STX><SI>wt,WPA2<ETX>
<STX><SI>wt,WPA_PSK<ETX>
<STX><SI>wt,ROAM<ETX>
<STX><SI>wt,PWR_MODE<ETX>
<STX><SI>wt,CHANNEL<ETX>
<STX><SI>wt,AP_MAC<ETX>
<STX><SI>wt,SIGNAL<ETX>
<STX><SI>wt,SPEED<ETX>
<STX><SI>wt,ACTIVE<ETX>
If you have a Fingerprint version of the printer, s end this
command to the PB51:
setup write "wlan","uart1:"
modes. See one of the following procedures to con gure wireless
printing on your IPL or Fingerprint printer.
certi cate to the printer. The printer can accept .pfx, .pem, and
.der certi cates.
sure it has an IP address allocated to it.
Description
Excellent signal
Strong signal
Good signal
PB51 Mobile Label and Receipt Printer User's Guide