Table of Contents
Advertisement
KTD-N0904-E
DC Power Jack Connector (5Vin Ext.)
6.2
Either the DC Power Jack Connector (5Vin Ext.) or the "5Vin Int." connector must be used to supply the
board with +5V +/-5%.
The 5Vin Ext. power connector has Vin to the center pin and mates with Ø 6.3 mm DC Power jack with Ø 2.0
mm pin hole. (DC Connector RA 2mm locking type). Maximum allowed current is 5A.
Warning: Hot Plugging power supply is not supported. Hot plugging might damage the board.
To protect the external power lines of peripheral devices make sure that
Notes:
- the wires have the right diameter to withstand the maximum available current.
- to enclosure of the peripheral device fulfills the fire-protecting conditions of IEC/EN 60950.
Page 21
pITX-E38 Users Guide
IO-Area Connectors
Advertisement
Table of Contents
