Serial Com1 - Com2 Ports (Com1, Com2) - Kontron pITX-E38 Manual

KTD-N0904-E
Serial COM1 – COM2 Ports (COM1, COM2)
7.4
Two RS232 serial ports (TTL signals only) are available on the pITX-E38.
Header
The typical definition of the signals in the COM ports is as follows:
Signal Description
Transmitted Data, sends data to the communications link. The signal is set to the marking state
TxD
(0V) on hardware reset when the transmitter is empty or when loop mode operation is initiated.
RxD Received Data, receives data from the communications link.
RTS Request To Send, indicates to the modem etc. that the on-board UART is ready to exchange data.
CTS Clear To Send, indicates that the modem or data set is ready to exchange data.
Available cable kit:
For more detailed information how to set up the COM ports please find KTD-N0914 "pITX-E38 COM port
Application Note" on EMD Customer Section
login.php?redirect_to=/
Page 26
Pin Signal
1 TxD
2 RxD
3 RTS
4 CTS
5 GND
1055-8059 Cable Serial 5p 20cm OE pITX-E38
http://emdcustomersection.kontron.com/wp-
pITX-E38 Users Guide
IO-Area Connectors
Description Type
TTL signal
TTL signal
TTL signal
TTL signal
Ground PWR
O
I
O
I