COBHAM EXPLORER 3075GX Installation And User Manual page 67

Error code
Severity
(ID)
0810D-0 ADM ERROR
08800-0 ADM ERROR
08840-0 ADM WARNING Master PLL lock
08841-0 ADM ERROR
08842-0 ADM WARNING GSC demodulator
08843-0 ADM WARNING DVBS demodulator
08844-0 ADM WARNING BUC voltage
08845-0 ADM WARNING LNB voltage
08880-0 ADM ERROR
08A00-0 ADM WARNING GX Core Module fan
08A01-0 ADM WARNING GX Core Module heater
08A02-0 ADM WARNING GX Core Module temperature The Core Module temperature is out of
08A03-0 ADM ERROR
08A04-0 ADM WARNING iDirect modem
98-144390-A
Description
Antenna communication
Internal power supply
Tuner lock
WLAN configuration error
GX Core Module power
Table B-1: Event messages (Continued)
Appendix B: System messages
Explanation
Link to the ACU could not be established.
Either the ACU is malfunctioning, or - if the
system software has just been updated - the
software is too old and is not compatible
with the ACU hardware.
An internal power supply voltage is outside
its legal range.
The master PLL has lost lock. Check the
input reference signal.
The internal tuner PLL was unable to lock.
The GSC demodulator has reported an error.
The DVBS demodulator cannot be initialised
and loaded correctly.
The BUC voltage is out of range.
The LNB voltage is out of range. The LNB
might be switched off to protect the power
supply circuitry. Reactivate satellite profile
to try again, check LNB cable and
surroundings if the problem persists.
Configuration of WLAN module failed.
There is a problem with the Core Module
fan. Check/clean and replace if necessary.
There is a problem with the Core Module
heater. Check and replace if necessary.
range. It may affect performance, and it will
be shut down if the situation gets worse.
The Power Good signal from the Core
Module is low. Check cables.
The ACU detected a warning/error in the
iDirect modem. Log into the modem for
more information. Info:
0x00000001: Temperature error
0x00000002: Test error
0x00000004: Fan error
List of events
B-3