Table of Contents
Advertisement
Digital Projection Mercury Quad Series
Setup menu continued from previous page
ColorMax Setting
ColorMax Setting
permits seven point
color matching of red, green, blue,
yellow, cyan, magenta and white.
You can enter your own gamut values
here, or edit values you have imported
using the Projector Controller
software.
Defining your own colorspace with
individual x and y coordinates for each
color enables you to match not only the
whites but each individual color as well.
Highlight the submenu you wish to
open and press
to confirm
ENTER/OK
your choice.
Measured Data / Target Data
1.
Use the
UP
and
DOWN
arrow
buttons to highlight a color, then
use the
and
LEFT
RIGHT
arrow buttons to navigate to the
x
or
y
coordinate.
2.
Use the
and
arrow
UP
DOWN
buttons to increase and decrease
the value, respectively.
3.
Exit edit mode:
•
press
ENTER/OK
, if you want
to save the edited values.
•
press
, if you do not wish
EXIT
to save the edited values
4.
If necessary, highlight another color
and repeat the procedure.
Operating Guide
Measured Data
Red
x: 0.658
y: 0.339
Green
x:
0.315
y: 0.662
Blue
x: 0.146
y: 0.043
White
x: 0.276
y: 0.283
USING THE PROJECTOR
ColorMax Setting
Measured Data
Target Data – User 1
Target Data – User 2
Reset
Target Data – User 1
Red
Green
Blue
Yellow
Cyan
Magenta
White
u
u
The Projector Controller software
u
is available for download from the
Digital Projection website, free of
charge.
This tool is best used in conjunction
with a specialized light meter (a
photo spectrometer) to measure
color parameters within a particular
installation. However, the preloaded
generic factory default data set
is designed to give more than
satisfactory results.
A
Target Data
available if
x: 0.640
y: 0.390
to
User 1
x: 0.300
y: 0.600
x:
0.150
y: 0.060
x: 0.419
y: 0.505
x: 0.225
y: 0.329
x: 0.321
y: 0.154
x: 0.285
y: 0.302
Notes
submenu is only
Color > ColorMax
is set
or
User 2
.
Rev A March 2017
page 71
Advertisement
Table of Contents
