OSEE BCM-156-3HSV User Manual page 70

Functionality of the Main Menu
BCM-156
 Cable1
Use Cable1 to connect one of the COM3~COM6 interface at the rear
panel of TSI-3000 with the RS485 Interface of BCM-156, the functionality
of the interfaces are as shown in the following table.
 RS485(BCM-156): RJ45
Use the RS485 interface to connect with TSI-3000, the RS485 uses the
RJ45 connector, and the function of RS485 interface of BCM-156 is
defined as in Table 5.1-17, please refer to the above Table 5.1-17 for
the details, no repeat here.
 COM(TSI-3000): 6P6C
Use one of the COM3~COM6 interface at the rear panel of TSI-3000 to
connect with BCM-156 monitor, the COM3~COM6 has the 6P6C
connector, and the function of COM3~COM6 interface of TSI-3000 is
defined as in Table 5.1-20:
PIN No. 6P6C
1 Rx-(data from external device)
2 GND(Data Common)
3 Tx+(data to external device)
4 Tx-(data to external device)
5 Not connected
6 Rx+(data from external device)
The connection should obey the rules below to set up the communication
between one of COM3~COM6 and RS485, as shown in Table 5.1-21:
Table 5.1-21 Connection Between COM3~COM6 of TSI-3000 and RS485
Table 5.1-20 The Pins of COM* in TSI-3000
of BCM-156
6P6C(COM3~COM6) RJ45(RS485)
1
3
2
5 (Not connected)
Illustration
3
4
2
1(Not connected)
64