OSEE BCM-156-3HSV User Manual page 62

Functionality of the Main Menu
triggered, refer to Table 5.1-14 for the details.
 GPI control: when it changes it would be as a control value of response
control. If the level does not change, but there are other control caused by
changes in the control value, perform this change. When boot, detect the
GPI input status after initialization. If a GPI value is low, the monitor will
control the corresponding operation. The TALLY is directly control by the
level.
Table 5.1-14 The Description for GPI Items and Their Trigger
Items Function
Enable/Disable the display of
AREA MARKER
area marker.
CENTER Enable/Disable the display of
MARKER center marker.
SAFETY Enable/Disable the display of
MARKER safety marker.
ASPECT Set the aspect ratio.
Switch
MONO
monochrome and color.
Switch scan mode between
OVER SCAN
over and normal.
Switch scan mode between
UNDER SCAN
under and normal.
Switch between blue only
BLUE ONLY
and normal.
Switch between native and
NATIVE
normal.
Switch between H delay and
H DELAY
normal.
Switch between V delay and
V DELAY
normal.
Switch between H/V delay
H/V DELAY
and normal.
Switch the input source to
SDI1
SDI1.
Trigger
Low: Enabled; High: Disabled
Low: Enabled; High: Disabled
Low: Enabled; High: Disabled
Low: 16:9; High: 4:3
between the
Low: MONO; High: NORMAL
Low: OVER; High: NORMAL
Low: UNDER; High: NORMAL
Low:
NORMAL
Low: NATIVE(In center); High:
NORMAL
Low: H DELAY; High: NORMAL
Low: V DELAY; High: NORMAL
Low:
NORMAL
Switch at the falling edge, when
switching to the other input, exit.
56
BLUE ONLY;
H/V DELAY;
High:
High: