OSEE BCM-156-3HSV User Manual page 66

Functionality of the Main Menu
 If IMD DISPLAY item is ON, the IMD CHARACTER in the black bar will
display on the bottom of the screen.
 The length of IMD NAME and IMD CHARACTER is up to 16 characters.
The character range is from 0x00 to 0x7F of ASCII. Press ENTER to edit
the IMD characters, than use UP or DOWN to select characters, than press
ENTER to go to next character, press MENU to exit editor.
 When the IMD PROTOCAL is set to be Local, the IMD CHARACTER can
only be modified through the control buttons(∧(Up) and ∨(Down)), and
the IMD CHARACTER could be composed of up to 16 characters. When
the IMD PROTOCAL is set to be NETWORK, the IMD CHARACTER
should be modified through the IMD page in the network control page, and
the IMD CHARACTER could be composed of up to 16 characters or up to
12 Chinese characters. For other values of IMD PROTOCAL, the IMD
CHARACTER abides by the corresponding protocol.
The BCM-156 monitor could receive the Tally control signal from a TSL server,
and display the Tally information on BCM-156 through the LED tally and OSD
tally. We support the TSI3000 and TSL TallyMan Controller as the TSL server,
and it will be introduce how to connect with them, and how to set the IMD
parameters for various IMD protocol.
5.1.11.1 Device Connection
Follow the instructions below to connect monitor with TSL server.
TSI-3000--BCM-156
1.
Connect the TSI-3000 with BCM-156, as shown in Figure 5.1-35:
60