Display Mode; Usb Copy; Typical Setup Procedure - Thecus N4100PRO User Manual

The following table illustrates the keys on the front control panel:
LCD Controls
Icon Function
Up Button
▲
Down Button
▼
↵ Enter
ESC Escape
There are two modes of operation for the LCD: Display Mode and Management
Mode.

Display Mode

During normal operation, the LCD will be in Display Mode.
Display Mode
Item
Host Name
WAN
LAN
Link Aggregation
Disk Info
RAID
System Fan
2006/06/16 12:00
The N4100PRO will rotate these messages every one-two seconds on the LCD
display.

USB Copy

The USB Copy function enables you to copy files stored on USB devices such as USB
disks and digital cameras to the N4100PRO with a press of a button. To use USB
copy, follow the steps below:
1. Plug your USB device into an available USB port on the Front Panel.
2. In Display Mode, press the Enter (
3. The LCD will display "USB Copy?"
4. Press Enter (
the front USB port.
5. All of data will be copied into system folder named "USBcopy".

Typical Setup Procedure

From the Web Administration Interface, you can begin to setup your N4100PRO for
use on your network. Setting up the N4100PRO typically follows the five steps
outlined below.
For more on how to use the Web Administration Interface, see Chapter 4: System
Management > Web Administration
Description
Select the previous configuration settings information.
Select the next configuration settings information
Enter for the USB copy confirmation message.
Escape and return to the previous menu.
Description
Current host name of the system.
Current WAN IP setting.
Current LAN IP setting.
Current Link Aggregation status
Current status of disk slot has been installed
Current RAID status.
Current system fan status.
Current system time.
↵
) and the N4100PRO will start copying USB disks connected to
↵
).
Interface.
18