Typical Setup Procedure - Thecus VisoGuard V2510 User Manual

Nvr server
Table of Contents

Advertisement

2. In Display Mode, press the Enter (
3. The LCD will display "USB Copy?"
4. Press Enter (
connected to the front USB port. The LCD will display the USB copy progress
and results.

Typical Setup Procedure

From the Web Administration Interface, you can begin to setup your Thecus
VisoGuard for use on your network. Setting up the Thecus VisoGuard typically
follows the five steps outlined below.
For more on how to use the Web Administration Interface, see
Chapter 4:
Web Administration
Step 1: Network Setup
From the Web Administration Interface, you can configure the network settings of
the Thecus VisoGuard for your network. You can access the Network menu from
the menu bar.
For details on how to configure your network settings, refer to
Chapter 4:
System Network
Step 2: RAID Creation
Next, administrators can configure their preferred RAID setting and build their
RAID volume. You can access RAID settings from the menu bar of the Web
Administration Interface by navigating to Storage Management > RAID
Management.
For more information on configuring RAID, see
Chapter 4: Storage >
Don't know which RAID level to use? Find out more about the different RAID levels
from
Appendix
: RAID
B B B B
Step 3: Create Local Users or Setup Authentication
Once the RAID is ready, you can begin to create local users for Thecus VisoGuard.
For more on managing users, go to Chapter 4:
Step 4: Create Folders and Set Up ACLs
Once users are introduced into your network, you can begin to create various
folders on the Thecus VisoGuard and control user access to each using Folder
Access Control Lists.
More information on managing folders, see
Chapter 4: Storage Management >
To find out about configuring Folder Access Control Lists, see Chapter 4: Storage
Management > Share Folder>
Step 5: Start Services
Finally, you can start to setup the different services of Thecus VisoGuard for the
users on your network. You can find out more about each of these services by
clicking below:
↵ ↵ ↵ ↵
) and the Thecus VisoGuard will start copying USB disks
Interface.
.
RAID
Management.
Basics.
Share Folder
Folder Access Control List
↵ ↵ ↵ ↵
).
User and Group Authentication.
.
29
(ACL).

Advertisement

Table of Contents
loading

Table of Contents