Table of Contents
Advertisement
To do...
1.
Enter system view.
2.
Enter user profile view.
3.
Specify a permitted
SSID.
4.
Return to system view.
5.
Enable the user profile.
For more information about user access control and user profile, see Security Configuration Guide.
WLAN service configuration examples
WLAN service configuration example
Network requirements
As shown in
Figure
a plain-text wireless access service with SSID service. 802.1 1g is adopted.
Figure 9 Network diagram for WLAN service configuration
Configuration procedure
Configure the fat AP.
1.
# Create a WLAN BSS interface.
<AP> system-view
[AP] interface wlan-bss 1
[AP-WLAN-BSS1] quit
# Configure a clear type WLAN service template, with no authentication.
[AP] wlan service-template 1 clear
[AP-wlan-st-1] ssid abc
[AP-wlan-st-1] authentication-method open-system
[AP-wlan-st-1] service-template enable
[AP-wlan-st-1] quit
# Bind WLAN-Radio 2/0 to service template 1 and WLAN-BSS 1.
Use the command...
system-view
user-profile profile-name
wlan permit-ssid ssid-name
quit
user-profile profile-name enable
9, enable the client to access the internal network resources at any time. The AP provides
AP
Switch
Remarks
—
Required.
If the specified user profile does not
exist, this command creates it and
enters its view.
Required.
No permitted SSID is specified by
default, and users can access the
WLAN without SSID limitation.
—
Required.
Not enabled by default.
Client
20
Advertisement
Table of Contents
