Byte 0: Multiplier For The Velocity (V) - Siemens SIMATIC S5 Manual

Addressing and Programming
4.2.2

Byte 0: Multiplier for the Velocity (V)

Bit 0 to 7: You must enter a binary value between 1 and 255 in byte 0. You can
calculate the stepping rate according to the following formula:
f =
A
BV =
V =
R =
Note:
You can enter values from 1 to 255 for the multiplier. The maximum stepping
rate with a base value of BV =800 Hz is then 204 kHz. The IP 267 cannot
generate stepping rates lower than the preset start/stop rate (f
stepping rates are corrected to the value of f
4-10
f (Hz) = BV(Hz) *
A
Stepping rate of the motor
Base value for the frequency ( Table 4-4.)
Multiplier for the velocity (1 to 255)
Reduction factor (1 or 0.1). The factor is determined in the
current positioning job
ss
V R
*
.
EWA 4NEB 812 6061-02a
IP 267
). Lower
ss