Dell X1000 Series User Manual page 325

FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\Dell Astute\User
• Global — A globally unique IPv6 address; visible and reachable
from different subnets.
– IP Address — Enter the receiver's IP address.
4 Enter the fields:
– UDP Port — Port to which SYSLOG message are sent.
Maximum Datagram Size (Bytes) — Maximum number of bytes that
–
can be sent to the receiver in a single sample datagram (frame).
sFlow Interface Settings
To sample datagrams or counters from a port, the port must be associated
with a receiver. sFlow port settings can be configured only after a receiver has
been defined in the
To enable sampling and configure the port from which to collect the sFlow
information:
1 Click Network Administration > sFlow > sFlow Interface Settings.
The sflow interface settings are displayed.
2 To associate an sFlow receiver with a port, click Edit, Add, and enter the
fields:
– Interface Type — Displays the interface type, which is Port.
– Interface — Select the port from which information is collected.
– Flow Sampling — Enable/disable flow sampling. Flow sampling
cannot be disabled if Counters Sampling is disabled.
– Flow Sampling Average Sampling Rate — If x is entered, a flow
sample will be taken for each x frames.
– Flow Sampling Receiver Index — Select one of the indices that was
defined in the
Flow Sampling Maximum Header Size (Bytes) — Maximum number
–
of bytes that should be copied from a sampled packet.
– Counters Sampling — Enable/disable counters sampling. Flow
sampling cannot be disabled if Flow Sampling is disabled
Counters Sampling Interval (Sec) — If x is entered, this specifies that
–
a counter sample will be taken for each x seconds.
D E L L C O N F I D E N T I A L – P R E L I M I N A R Y 8 / 9 / 1 6 - F O R P R O O F O N L Y
Guide\Dell_Astute_Network_Admin_sFlow.fm
sFlow Receiver Settings
sFlow Receiver Settings
pages.
pages.
Network Administration: sFlow
325