Dell X1000 Series User Manual page 117

FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\Dell Astute\User
– Interface — Select the specific interface to which the rule applies.
– Source IP Address — Select Enable/Disable to allow or not allow
access, restriction based on the source IP address. When this field is
disabled, the source IP address cannot be entered into a configured
rule.
– Supported IP Format — Select whether the IPv4 or IPv6 format is
supported for the source IP addresses.
– IP Address — Enter the interface source IP address for which the rule
applies. This is an optional field and indicates that the rule is valid for
a subnetwork.
– Address Class — Select one of the following options:
Subnet Mask
•
Format is IPv4.
Prefix Length
•
source IP address prefix, or the network mask of the source IP
address.
– Subnet Mask — Enter the subnet mask of the IP address of the
device.
Prefix Length — Enter the number of bits that comprise the IP
–
address prefix of the subnetwork.
– Action — Select whether to permit or deny management access to the
defined interface. The possible options are:
Permit
•
Deny
•
To activate a profile
1 Click Switch Management > Management Security > Access Profiles
and Rules.
The currently-defined access profiles are displayed.
2 To activate an access profile, select it in the Active Access Profile field.
3 Click Edit, Settings Icon ( ).
4 Select one of the following options for Access Profile Name:
– None — Access is available to all.
D E L L C O N F I D E N T I A L – P R E L I M I N A R Y 8 / 9 / 1 6 - F O R P R O O F O N L Y
Guide\Dell_Astute_SwitchManagement.fm
— Enter the IP subnetwork mask if Supported IP
— Enter the number of bits that comprise the
— Permits access to the device.
— Denies access to the device.
Switch Management
117