Maintenance - Icom IC-2SA Instruction Manual

MAINTENANCE
6-1 Troubleshooting
@ Charge the battery pack. @ No power comes ON. ® Battery pack requires charging.
@ Clean debris from the terminals of the bat-
tery pack and the transceiver.
@ Poor connection between the battery pack
and the transceiver.
e Rotate [SQL] counterclockwise.
@eNo sound comes from the e [SQL] turned too far clockwise.
speaker.
® Battery pack requires charging. ® Charge the battery pack.
@ Power off timer is activated. e Turn power OFF and ON again.
@An external speaker or earphone is con-
nected.
@ Unplug speaker or earphone.
@No transmitting is possible or | @ Battery pack requires charging. @ Charge the battery pack.
only Low power can be used.
@ Low power position is selected. @ Select High output power.
e Turn OFF the function.
@ePush [C] to return to VFO or MEMORY
mode.
@ Only memory channels 0 ~ 9 @Memory channels 10 ~ 47 are in blank eSelect a memory channel after pushing | p. 12
can be used. status. [FUNC].
@ Scan does not operate. ® Call channel is selected. e Set in VFO or MEMORY mode.
® Rotate [SQL] clockwise.
e The transceiver is in the special operating | @While pushing [LIGHT] and [V/M], turn
condition. power ON.
@The [C] switch cannot call | @The transceiver is in the special operating | @While pushing [LIGHT] and [V/M], turn
the call channel. condition. power ON.
® The contents of the memories | @ The backup battery is exhausted because no | @ Charge the battery pack (backup battery is
are erased. charging has been performed for a long time. charged simultaneously ).
@ Frequency cannot be set. @ Lock function is activated.
® Call channel is selected.
© Squeich is open.