Security Setup; Storage Setup - Intec CP2020 Configuration Manual

S
ECURITY SETUP
ITEM
Job Limitation
Reset Cipher Key
S S
TORAGE ETUP
ITEM
Check File
System
Check All Sectors
VALUE
Off
Encrypted Job
Execute
VALUE
Execute
Execute
Appendix: the printer menu > 79
DESCRIPTION
Controls the job limitation mode. If
Encrypted Job is selected the printer will
only allow this type of job to be printed
and will discard all others.
Resets the cipher key used for the
encrypted hard disk. The data on the
drive before the operation performed with
this menu cannot be restored after the
operation. Execute displays the following
confirmation message:
Are Your Sure?
- Yes
- No
By selecting No, the display returns to the
previous, menu screen. Selecting Yes
reboots the printer automatically,
resetting the cipher key.
Display condition:
- An applicable HDD has been installed in
the printer.
- The encrypted hard disk function is
enabled.
DESCRIPTION
Resolves any mismatch between actual
memory and displayed memory available
in a file system and performs
administration data (FAT information)
recovery. Performs these by file system.
This function takes several tens of
seconds to complete.
HDD: Performs recovery only for an HDD.
Performs recovery of a defective HDD
sector information and a file system
mismatch as mentioned above.
It takes 30 to 40 minutes to complete this
function for an HDD of 10GB.