Intec CP2020 Configuration Manual page 64

ITEM VALUE
Binding LongEdge
ShortEdge
Job offset ON
OFF
Output bin Facedown
Faceup
Facedown
Finisher
Finisher Setup
This appears only if the optional finisher is installed. See the documentation
supplied with the finisher for information on setting it up.
Media check Enable
Disable
Transparency Auto
detect Disable
Resolution 600dpi
600x1200dpi
600dpi multi-level
Toner save ON
mode OFF
Mono-print Auto
speed Colour speed
Normal speed
Default Portrait
orientation Landscape
Form length 5 ~ 60 (L) ~ 64 (A) ~
128 lines
Appendix: the printer menu > 64
DESCRIPTION
Specifies how to bind duplex
printing.
Enables/Disables Job offset.
Specifies where to eject prints.
Specifies where to eject prints when
a Finisher is installed.
Enables/Disables whether the
printer checks that paper size
required by the print data matches
that of the tray. Only standard sizes
can be checked.
Enables/Disables the automatic
detection of transparencies. (Use it
while detecting sensor mistakes).
Sets the resolution.
Sets toner saving mode.
Sets the monochrome print speed.
Auto: prints at most appropriate
speed for page.
Colour speed: always prints at
colour speed.
Normal speed: always prints at
monochrome speed.
Sets printing orientation (only for
PCL, IBMPPR, EPSONFX). Invalid for
PS.
Sets the number of lines printable
on one page (only for PCL). Invalid
for PS.
The emboldened default values
given are for Letter (L) and A4 (A).
In practice, the values change
corresponding to the size of paper in
the tray.