Cannot Print With Lpr And Ftp; Web Browser - Intec CP2020 Configuration Manual

> Check the IP Address, Subnet Mask and Gateway are
correct.
> Check that the TCP/IP protocol is set to Enable.
> Reset the network interface card to factory default
settings.
> If DHCP, BOOTP and RARP are not used, ensure they have
been set to Disable.
C
ANNOT PRINT WITH
> Turn the printer off for 15 seconds and then on again.
> Check there is a response to the ping command.
> Check the network cable is correctly connected.
> Change the cable and try again.
> Check the host name and IP address are configured in the
workstation.
> Check the printer port name is configured in the
workstation.
> There are three port names: lp, euc and sjis. Use lp by
default as euc and sjis are specific to PostScript printers.
W
EB BROWSER
If you are using the Web browser to configure your machine
settings, but do not see the most recent settings displaying on
the Web page, you should temporarily switch off your browser's
page caching. To prevent your web browser caching the printer
web pages, carry out the following steps as appropriate for your

web browser.

NOTE
Keeping this setting enabled all the time may slow down web
browsing. You may want to revert to the browser default
setting once you have finished using the printer web page.
LPR FTP
AND
Section 5: troubleshooting > 50