Intec CP2020 Configuration Manual page 66

PS Setup
ITEM VALUE
Network ASCII
protocol RAW
Parallel ASCII
protocol RAW
USB protocol ASCII
RAW
PCL Setup
ITEM VALUE
Font Resident
source Resident2
Downloaded
Font 10
Number C0
S1
Font pitch 0.44 ~ 10.00 ~ 99.99 CPI
Font 4.00 ~12.00 ~ 999.75 point
height
DESCRIPTION
Specifies PS transmission protocol for network
data. It does not appear for Non-PS type.
Specifies PS transmission protocol for
Centronics data. It does not appear for Non-PS
type.
Specifies PS transmission protocol for USB
data. It does not appear for Non-PS type.
Appendix: the printer menu > 66
DESCRIPTION
Specifies the location of the PCL
default font.
RESIDENT2: displayed only
when Heisei Font is installed.
DOWNLOADED: displayed when
software font is downloaded to
RAM as permanent designation.
Fonts downloaded to Flash and
HDD by PJL command are not
displayed in this menu.
Sets the PCL font number.
Sets the width of the PCL default
fonts.
Sets the height of the PCL default
font.