Intec CP2020 Configuration Manual page 71

ITEM
Left margin
Fit to letter
Text height
Cont paper mode
Colour setup
ITEM VALUE
Ink simulation OFF
SWOP
Euroscale
Japan
UCR Low
Medium
High
CMY 100% Enable
density Disable
CMYK ON
conversion OFF
VALUE
0.0 inch
0.1 ~ 1.0 inch
Enable
Disable
Same
Diff
ON
OFF
DESCRIPTION
Simulates a standard printing colour by the
printer. The function is valid only for jobs using
PS languages.
Sets toner layer thickness. (Medium or Low
may help reduce any paper curl that occurs.)
Enable/disable 100% output against CMY100%
TRC compensation. Ordinarily, the TRC
compensation function produces appropriate
print density, so 100% output is not always
enabled.
Selecting ENABLE will enable 100% output in
individual colour. The actual print, including the
TRC compensation function is limited to an
appropriate area. This function is for a special
purpose such as specification in CMYK colour
diminution of PS.
Set to OFF to simplify the conversion process of
CMYK data and reduce the processing time.
This setting is ignored when the Ink Simulation
function is used.
Appendix: the printer menu > 71
DESCRIPTION
Sets the print position from
the left edge of the paper.
Sets the print mode that fits
print data equivalent to 11
inch (66 lines) into Letter size
printable area.
Sets character height.
Same: same height,
regardless of CPI.
Diff: character heights vary
according to CPI.
Sets the edit direction of
paper supported by A3
printer to landscape.