Heat Sink - HP EliteOne 800 G3 Maintenance & Service Manual

Heat sink

Heat sinks are available for models with integrated UMA graphics and with discrete graphics.
To remove the heat sink:
1. Prepare the computer for disassembly (see
2. Remove the rear port cover (see
3. Remove the stand (see
4. Remove the access panel (see
5. UMA models:
In the order indicated on the heat sink, loosen the captive Torx screws (1) from the heat sink component
that services the processor.
CAUTION:
downward forces on the processor. This is especially important as the pins on the socket are very fragile
and any damage to them may require replacing the system board.
6. Remove the non-captive Torx screws from the brackets at the top of the heat sink (2).
Removing the rear port cover on page
Stands on page
Access panel on page
Remove heat sink retaining screws in diagonally opposite pairs (as in an X) to even the
Preparing to disassemble the computer on page
20).
21).
19).
19).
Heat sink 35