HP EliteOne 800 G3 Maintenance & Service Manual page 68

16. On the rear of the chassis, note the locations the cables route through (1), and the remove the cables
from the clips built into the chassis (2).
17. Peel the left antenna from the chassis (1), and then pull the other end of the cable through the hole in
the chassis (2). Remove the left antenna and cable.
To install the antenna, reverse the removal procedures.
NOTE: When connecting the antennas cables, be sure to match the numbers on the cable with the same
number printed on the WLAN module.
60 Chapter 4 Removal and Replacement Procedures