Making And Changing Basic Settings - Magnescale LY71 Instruction And Installation Manual

4-2. Making and Changing Basic Settings

Be sure to set the items that must be set before operation. If these settings are not made, you will be unable
to use the counter unit.
After performing the procedure in "4-1. Enabling Operation," make settings according to the actual application.
See "9-1. Setting Flowcharts" for the flow of setting operations.
To enter the basic setting mode
1
Hold down the key for 3 seconds or more while
Basic settings
The basic settings include the items shown in the table on page 4-4. Be sure to set each item.
Operation keys
Setting item selection/
Setting content change
Setting content finalization/
End item
Next item
Expanded selection options
LY71
is displayed.
: key • When pressed once, the ABS lamp flashes and
setting contents can be changed.
• When pressed in the change enabled status,
the setting contents change.
: key • Press while the ABS lamp is flashing to
validate the setting contents.
• Press after finalizing the setting contents to
end that setting item and proceed to the next
setting item.
: key • Press to proceed to the next setting item.
• Press partway through the setting process to
cancel the change contents and proceed to the
next setting item.
• Press the
: key
is flashing to increase the available selection
options for setting items that have expanded
selection options. Press the key again to return
to the original options
key while the ABS lamp
4. Settings
4-3
(E)