Settings; Enabling Operation (When Using The Ly71 For The First Time) - Magnescale LY71 Instruction And Installation Manual

4. Settings

You can use the LY71 after making the basic settings.
The basic settings determine the basic operation of the LY71, so be sure to make the basic settings after
displaying the counter.
See "9-1. Setting Flowcharts" for the flow of setting operations.

4-1. Enabling Operation (When Using the LY71 for the First Time)

If you are unsure of the setting method described in "4-2. Making and Changing Basic Settings," perform
the procedure below. This will let you confirm the basic operation.
1
When the power is turned on, the display lights on in the order
2
Press the key.
........ The display lights on in the order
3
Press the key.
........ The display lights on in the order
4
Press the key.
........ The ABS lamp flashes and settings can be changed.
Operation procedure (Starting settings)
If you press the
can change the setting item contents.
5
<When using other than inch units>
Proceed to step 6.
<When using inch units>
Press one time.
The display lights on in the order
STD Standard (mm display; inch display possible)
US U.S. (inch display; mm display possible)
JPN Japan (mm display only)
∗ Select the appropriate unit of measurement.
6
Press the key.
........ The setting is validated and the ABS lamp lights off.
Operation procedure (Finalizing settings)
If you press the
the ABS lamp lights off.
7
Press the key again.
........ The display lights on in the order
Operation procedure (To next item)
If you press the
item.
LY71
→
key when each setting item is displayed, the ABS lamp flashes and you
→
.
key while the ABS lamp is flashing, the set contents are validated and
key after finalizing a setting, operation proceeds to the next setting
→
.
→
.
→
.
→
.
4-1
(E)