Forcefully Shutting Down A Tracked Port; Displaying Port Tracking Information - Cisco Nexus 5500 Series NX-OS Configuration Manual

Configuring Port Tracking

Forcefully Shutting Down a Tracked Port

You can forcefully shut down a tracked port.
Procedure
Step 1
Step 2
Step 3
Step 4

Displaying Port Tracking Information

The show commands display the current port tracking settings for the switch.
The following example shows how to display tracked port configuration for a specific interface:
switch# show interface vfc21
fc2/1 is down (Administratively down)
5 minutes input rate 0 bits/sec, 0 bytes/sec, 0 frames/sec
...
OL-30895-01
Command or Action
configure terminal
Example:
switch# configure terminal
switch(config)#
switch(config)# interface fc slot/port
port-track force-shut
Example:
switch(config-if)# port-track
force-shut
no port-track force-shut
Example:
switch(config-if)# no port-track
force-shut
Hardware is Fibre Channel, FCOT is short wave laser w/o OFC (SN)
Port WWN is 20:01:00:05:30:00:0d:de
Admin port mode is FX
Port vsan is 1
Receive data field Size is 2112
Beacon is turned off
Port tracked with interface vc22 (down)
Port tracked with interface san-port-channel 1 vsan 2 (down)
Cisco Nexus 5500 Series NX-OS SAN Switching Configuration Guide, Release 7.x
Displaying Port Tracking Information
Purpose
Enters global configuration mode.
Configures the specified interface and enters the
interface configuration mode. You can now
configure tracked ports.
If this is a QSFP+ GEM, the slot/port
Note
syntax is slot/QSFP-module/port.
Forcefully shuts down the tracked port.
Removes the port shutdown configuration for the
tracked port.
285