Configuring VSAN Trunking
VSAN 2 can only be routed from switch 1 through switch 3 to switch 2.
Figure 19: Operational and Allowed VSAN Configuration
Configuring an Allowed-Active List of VSANs
You can configure an allowed-active list of VSANs for an interface.
Procedure
Step 1
Step 2
Step 3
OL-30895-01
Command or Action
configure terminal
Example:
switch# configure terminal
switch(config)#
switchport trunk allowed vsan vsan-id - vsan-id
Example:
switch(config-if)# switchport trunk allowed vsan
35-55
switchport trunk allowed vsan add vsan-id
Example:
switch(config-if)# switchport trunk allowed vsan
add 40
Cisco Nexus 5500 Series NX-OS SAN Switching Configuration Guide, Release 7.x
Configuring VSAN Trunking
Purpose
Enters global configuration mode.
Changes the allowed list for the
specified VSAN range.
Expands the specified VSAN to the
new allowed list.
89