Configuring Fibre Channel Interfaces
Information About N Port Identifier Virtualization
N port identifier virtualization (NPIV) provides a means to assign multiple FC IDs to a single N port. This
feature allows multiple applications on the N port to use different identifiers and allows access control, zoning,
and port security to be implemented at the application level. The following figure shows an example application
using NPIV.
Figure 1: NPIV Example
Enabling N Port Identifier Virtualization
You can enable or disable NPIV on the switch.
Before You Begin
You must globally enable NPIV for all VSANs on the switch to allow the NPIV-enabled applications to use
multiple N port identifiers.
Note
All of the N port identifiers are allocated in the same VSAN.
Procedure
Step 1
OL-30895-01
Command or Action
Command or Action
configure terminal
Example:
switch# configure terminal
switch(config)#
Cisco Nexus 5500 Series NX-OS SAN Switching Configuration Guide, Release 7.x
Configuring Global Attributes for Fibre Channel Interfaces
Purpose
The default setting is trunk mode
Note
on.
Purpose
Enters configuration mode.
23