Configuring Dhchap Aaa Authentication; Displaying Protocol Security Information - Cisco Nexus 5500 Series NX-OS Configuration Manual

Configuring DHCHAP Authentication
Procedure
Step 1
Step 2
Step 3

Configuring DHCHAP AAA Authentication

You can configure AAA authentication to use a RADIUS or TACACS+ server group. If AAA authentication
is not configured, local authentication is used by default.

Displaying Protocol Security Information

Use the show fcsp commands to display configurations for the local database.
The following example shows how to display the DHCHAP configuration for the specified interface:
switch# show fcsp interface fc2/4
fc2/4
The following example shows how to display DHCHAP statistics for the specified interface:
switch# show fcsp interface fc2/4 statistics
The following example shows how to display the FC-SP WWN of the device connected to the specified
interface:
switch# show fcsp interface fc2/1 wwn
The following example shows how to display the hash algorithm and DHCHAP groups configured in the
switch:
switch# show fcsp dhchap
The following example shows how to display the DHCHAP local password database:
switch# show fcsp dhchap database
Use the ASCII representation of the device WWN to configure the switch information on RADIUS and
TACACS+ servers.
Cisco Nexus 5500 Series NX-OS SAN Switching Configuration Guide, Release 7.x
240
Command or Action
configure terminal
Example:
switch# configure terminal
switch(config)#
fcsp timeout timeout
Example:
switch(config)# fcsp timeout 60
no fcsp timeout timeout
Example:
switch(config)# no fcsp timeout 60
fcsp authentication mode:SEC_MODE_ON
Status: Successfully authenticated
Configuring FC-SP and DHCHAP
Purpose
Enters global configuration mode.
Configures the reauthentication timeout to
the specified value. The unit is seconds.
Reverts to the factory default of 30 seconds.
OL-30895-01