Emerson Rosemount 2051 Quick Start Manual page 6

Quick Start Guide
Figure 6. Common Transmitter Assemblies
4 × 1.75-in. (44 mm)
B
4 × 2.88-in. (73 mm)
A. Transmitter with coplanar flange
B. Transmitter with coplanar flange and optional flange adapters
C. Transmitter with traditional flange and optional flange adapters
D. Transmitter with coplanar flange and optional manifold and flange adapters
Bolts are typically carbon steel or stainless steel. Confirm the material by viewing
the markings on the head of the bolt and referencing
not shown in
information.
2.5 Bolt installation
1. Carbon steel bolts do not require lubrication and the stainless steel bolts are
coated with a lubricant to ease installation. However, no additional lubricant
should be applied when installing either type of bolt.
2. Finger-tighten the bolts.
3. Torque the bolts to the initial torque value using a crossing pattern.
See Table 1
4. Torque the bolts to the final torque value using the same crossing pattern.
See Table 1
5. Verify the flange bolts are protruding through the isolator plate before
applying pressure.
2.6 Bolting considerations
If the transmitter installation requires assembly of the process flanges, manifolds,
or flange adapters, follow these assembly guidelines to ensure a tight seal for
optimal performance characteristics of the transmitters. Use only bolts supplied
with the transmitter or sold by Emerson as spare parts.
common transmitter assemblies with the bolt length required for proper
transmitter assembly.
6
A
Table 1, contact a local Emerson representative for more
for initial torque value.
for final torque value.
C
4 × 2.25-in.
(57 mm)
4 × 1.75-in.
4 × 1.75-in.
(44 mm)
(44 mm)
D
4 × 1.75-in. (44 mm)
Table 1. If bolt material is
Figure 6 illustrates
May 2017