Removing The Bottom Cover - HP 8568B Installation And Verification Manual

1. Disconnect the ac line cord from the RF section.
2. Using a screw driver, remove the two RF-section rear panel
bumpers. See callout 1 in Figure 2-15.
Figure 2-15. Removing the Bottom Cover
3. Back out screw 2 (see Figure 2-15) and the cover unseats from the
front frame. When the cover is clear of the rear frame, remove the
cover by lifting up.
4. Remove the cover from the Al5 controller assembly. See
Figure 2-16 to locate the assembly.
T O P D O W N
Installation 2-21