Installing The Option; Remove The Front Covers And Digital Operator - YASKAWA pg-b3 Installation Manual

Yaskawa ac drive 1000-series option complementary type pg

Hide thumbs Also See for pg-b3:

Table of Contents

5 Installation Procedure

◆

Installing the Option

Refer to the instructions below to install the option.

Shut off power to the drive, wait the appropriate amount of time for voltage to

dissipate, then remove the digital operator (E) and front covers (D, F). Refer to the

Quick Start Guide packaged with the drive.

DANGER! Electrical Shock Hazard. Disconnect all power to the drive and wait at least the amount of time

specified on the drive front cover safety label. After all indicators are off, measure the DC bus voltage to

confirm safe level, and check for unsafe voltages before servicing to prevent electric shock. The internal

capacitor remains charged even after the power supply is turned off.

NOTICE: Damage to Equipment. Observe proper electrostatic discharge procedures (ESD) when handling

the option, drive, and circuit boards. Failure to comply may result in ESD damage to circuitry.

Figure 3

Figure 3 Remove the Front Covers and Digital Operator

YASKAWA ELECTRIC TOBP C730600 36C 1000-Series Option PG-B3 Installation Manual

Table of Contents