Connection - Gazer H714 User Manual

Note:
Gazer H714 MVR must be connected to the car's onboard
electrical system. For correct MVR installation, please contact
your car dealer or service station. To prevent the violation of
your car warranty rules and conditions, please consult with the
car service station authorized to perform warranty maintenance.
Connect the black wire (GND) to the car ground line. Connect the
yellow wire cable (BATT +) directly to +12V car battery terminal or
DC +12V power line. The red wire (ACC) must be connected to the
car's +12V ACC power line (ACC power goes ON and OFF
automatically when the car engine is ON or OFF).
This connection guarantees that the MVR turns on and starts
recording automatically when your car engine starts. The MVR
continues recording for one hour (set by default) after the engine is
switched off and only then the system shuts down. You can change
these settings (recording duration after the engine is off) by pressing
«Auto-off time» and «Parking Mode» icons in the settings menu.
Power consumption in this mode is 110 mA.
Connecting MVR
ACC
(red)
BATT+
(yellow)
GND
(black)
ENG
9