Gazer MMR51 SERIES User Manual page 11

Note: Use the remote control that comes in the supply package to
set up and control the mirror.
1. Interface language setting. Stop the recording by pressing the SEL/
REC button and then go to the settings menu by double pressing the MENU
button. Use the UP/DOWN buttons to navigate to the «Language» item
and select the interface language. You may then resume the recording by
pressing the SEL/REC button.
2. Date and time setting. The mirror allows adding date and time
watermarks to recorded videos. To set the correct date and time, stop the
recording by pressing the SEL/REC button and then go to the settings
menu by double pressing the MENU button. Use the UP/DOWN buttons
to navigate to the «Date and time» item and set the desired date and time.
You may then resume the recording by pressing the SEL/REC button.
3. Video resolution setting. The MVR supports the following video
recording resolutions: 2560x1080 @30fps; 2304x1296 @30fps; 1920x1080
@45fps; 1920x1080 @30fps; HDR1920x1080 @30fps; 1280x720 @60fps;
1280x720 @30fps. To select the recording resolution, first stop the
recording by pressing the SEL/REC button and then go to the settings
menu by double pressing the MENU button. Use the UP/DOWN buttons to
navigate to the «Video resolution» item and select the required parameter.
You may then resume the recording by pressing the SEL/REC button.
4. Loop recording. To enable/disable the МVR's loop recording function,
first stop the recording by pressing the SEL/REC button and then go to
the settings menu by double pressing the MENU button. Use the UP/
DOWN buttons to navigate to the «Loop recording» item and select the
required value from the available parameters. You may then resume the
recording by pressing the SEL/REC button.
Recommendation:
video clips allows minimizing pauses between them.
5. Automatic power-up on ACC signal. The mirror supports automatic
activation of the recording mode when АСС signal is transmitted (this function
is enabled by default). To disable this function, first stop the recording by
pressing the SEL/REC button and then switch to the settings menu by
double pressing the MENU button. Use the UP/DOWN buttons to navigate
to the «Recording activation» item and select the required parameter. You
may then resume the recording by pressing the SEL/REC button.
6. G-sensor. The mirror features a built-in G-sensor (a three-axis
accelerometer) that traces any sharp changes in the vehicle's driving pattern
(hard braking, acceleration, and impacts). Files recorded when the G-sensor
is tripped are automatically protected from deletion due to loop overwriting
Usage
Selecting the shortest duration of recorded
ENG
11