Mitsubishi QJ71C24N User Manual page 54

2 SYSTEM CONFIGURATION AND AVAILABLE FUNCTIONS
Dedicated instruction
FROM, TO
ONDEMAND
INPUT
OUTPUT
BIDIN
BIDOUT
SPBUSY
CSET (Receive data clear)
BUFRCVS
PRR
CSET (Initial setting)
CSET (Programmable controller
CPU monitoring function)
PUTE
GETE
UINI
CPRTCL
2 - 15
3 The dedicated instructions are unavailable for the MELSECNET/H remote I/O
station.
For the functions that use the dedicated instructions to make communication,
perform programming by the following methods.
Perform programming using the REMFR/REMTO instruction.
Perform programming using the REMFR/REMTO instruction and
I/O signal.
No method
Perform programming using the receive data clear request area
of the buffer memory.
No method
(Data cannot be received using an interrupt program)
Perform programming using the REMFR/REMTO instruction and
I/O signal.
No method
(Register/delete the programmable controller CPU using the MC
protocol or GX Configurator-SC.)
Perform programming using the REMFR/REMTO instruction and
I/O signal.
Perform programming using the REMFR/REMTO instructions
and I/O signals. (However, the station No. cannot be changed.)
No method
(Communications using the pre-defined protocol are not
available.)
4 Available for the MELSECNET/H remote I/O station of function version D or
later.
GX Developer Version 8.18U or later is required to use the function.
Method
MELSEC-Q
Explanation section
Appendix 9.2
Appendix 9.3
Appendix 9.4
Appendix 9.5
Appendix 9.4
Appendix 9.5
Appendix 9.6
Appendix 9.7
Appendix 9.8
Appendix 9.9
Appendix 9.11
Appendix 9.10
Appendix 9.12
2 - 15