Mitsubishi QJ71C24N User Manual page 151

6 DATA COMMUNICATION USING THE NON PROCEDURE PROTOCOL
6 - 7
POINT
(1) The position and size of the receive area in the buffer memory can be changed
with the GX Configurator-SC in accordance with the specifications of the
external device and the receive data length. (See Section 9.4.7.)
(a) When changing the position and size of the receive area in the buffer
memory with GX Configurator-SC, specify as follows:
1) Receive buffer memory head address designation
Designate the starting address for the area to be used as the receive
area in the user-definable area (address: 400
3FFF ).
H
2) Receive buffer memory length designation
Designate by address the length of the area (0001
used as the receive area in the user-definable area (address: 400
1AFF , 2600
H
(b) When changing the position and size of the receive area in the buffer
memory, if any of the functions below are used concurrently, make sure
that the addresses of the receive area do not overlap with the buffer
memory addresses assigned for storing transmission/receive data with the
functions.
1) MC protocol buffer memory read/write function
2) MC protocol on-demand function
3) Non procedure protocol transmission/receive function
4) Bidirectional protocol transmission/receive function
5) Pre-defined protocol function (transmission/reception data storage
area)
6) Communication data monitoring function
(2) When sending data from the external device to the Q series C24, one of the
following two adjustments should be made so that the relationship shown
below is maintained.
1) Reduce the transmission data size.
2) Increase the receive area.
Receive data storage area ≥ Size of data sent from the external device
to 3FFF ).
H H
MELSEC-Q
to 1AFF , 2600 to
H H H
to 1A00 ) to be
H H
to
H
6 - 7