Mitsubishi QJ71C24N User Manual page 148

6 DATA COMMUNICATION USING THE NON PROCEDURE PROTOCOL
6 - 4
• If the next data (LF, etc.) is not received within the time set in the non
reception monitoring time (timer 0) after CR is received, the Q series
C24 stores the received data up to CR to the buffer memory receive
data storage area and turns on the following signals to the
programmable controller CPU.
When non procedure and non reception monitoring time format is 0:
Reception abnormal detection (X4/XB)
When non procedure and non reception monitoring time format is 1:
Reception data read request (X3/XA)
External device
Q series C24
Reception abnormal detection (X4/XB)
[Format is 0]
Reception data read request (X3/XA)
[Format is 1]
1 In non procedure protocol, a message is received by the increase in
non reception monitoring time (timer 0) if the received complete code
and the received data count are not decided.
For the non procedure protocol at the non reception monitoring time
format, see the User's Manual (Application).
2 CR is included as 1 byte of data included in the message.
2) When the receive complete code is changed and an arbitrary code is
designated (00
(User defined receive complete code data is added to the end of the
message and sent from the external device).
When the Q series C24 receives the receive complete code data
changed by the user, it stores the receive data up to the receive complete
code to the buffer memory receive area and turned on the reception data
read request (X3/X4) to the programmable controller CPU.
External device
Q series C24
Reception data request (X3/XA)
3) When receive complete code not designated (FFFF
Reading by received data count is enabled.
See (2) for a description of reading by received data count.
designated)
H
MELSEC-Q
1
Timer 0
C
set time
R
( 2)
Receive complete code data
designated)
H
6 - 4