Table of Contents
Advertisement
Embroidering preparation
Overview Embroidery functions
1
2
3
Centering the embroidery hoop to the needle
Relocating the embroidery hoop facilitates threading when the needle is close to the embroidery hoop.
> Touch the icon «Embroidery hoop display/Embroidery hoop selection».
> Touch the icon «Center the needle to the embroidery hoop».
> Thread the upper thread (see page 46).
P
> Push the button «Start/Stop» to move the embroidery hoop back to the last position.
Moving the hoop to the back
To facilitate changing the bobbin, it is recommended to move the hoop to the back before threading. This
makes it easier to open the bobbin cover.
> Touch the icon «Embroidery hoop display/Embroidery hoop selection».
> Touch the icon «Move the hoop to the back».
> Thread the bobbin thread (see page 51).
P
> Push the button «Start/Stop» to move the embroidery hoop back to the last position. Pull the upper
Moving the module for the sewing mode
The embroidery module can be positioned so that any sewing projects can be carried out even if the module
is connected.
146
Centering the embroidery hoop to the needle 4
Moving the hoop to the back
Moving the module for the sewing mode
thread back if necessary.
1017815.0.04_2016-05_Manual_B765_EN
1
2
3
4
5
Grid on/off
5
Motif center
6
Virtual Positioning (is visible while scrolling)
Advertisement
Table of Contents
