Table of Contents
Advertisement
17.3 Error messages
Message on the display
Cause
Stitch number unknown.
Selection of the stitch pattern not
possible in the combi mode.
The feed dog is not lowered.
The selected needle and stitch
plate cannot be used in
combination.
The needle is not at its top end.
The upper thread is used up.
The upper thread has broken.
The bobbin thread is used up.
The bobbin thread has broken.
1017815.0.04_2016-05_Manual_B765_EN
Repair
> Check the entry and enter the new number.
> Combine other stitches.
> Push the button «Feed dog up/down» to lower the feed
dog.
> Replace the needle.
> Replace the stitch plate.
> Adjust the needle position via the handwheel.
> Rethread.
> Rethread.
> Rethread.
> Clean the hook.
> Rethread.
Attachment
173
Advertisement
Table of Contents
