Sewing A Test Sample; Determining The Buttonhole Slit Width - Bernina 765 SE Manual

Buttonholes
> Sew the buttonhole in the usual manner.
> Pull the cord until the loop disappears in the bartack.
> Pull the ends of the cord with a hand stitching-needle to the wrong side of the fabric and knot or secure.

9.6 Sewing a test sample

Always sew a test sample of the buttonhole on the same fabric: It is recommended to use the same stabilizer
and to select the same buttonhole. The test sample should also be sewn in the respective direction. By
sewing a test sample the settings can be adjusted until the sewing result is satisfying.
Alterations of the balance when sewing a manual standard buttonhole as well as the keyhole and the round
buttonhole affect both beads in the same way. With the manual keyhole or round buttonhole the alterations
affect both sides differently.
If the stitch counter function is used and alterations are made concerning the balance, the alterations affect
both buttonhole beads differently.
> Touch the icon «Buttonholes».
> Select the buttonhole.
> Select and attach the desired presser foot.
> Place the fabric under the presser foot and lower the presser foot.
> Press the foot control carefully and start sewing. Guide the fabric slightly.
> Check the balance while sewing and adjust if necessary.
> Check the test sample and make further amendments if necessary.

9.7 Determining the buttonhole slit width

The width of the buttonhole slit can be adjusted between 0.1 – 2.0 mm before sewing.
> Touch the icon «Buttonholes».
> Select the buttonhole.
> Touch the icon «i»-Dialog.
> Touch the icon «Buttonhole slit width».
0.6
> Turn the «Upper Multifunction knob» or the «Lower Multifunction knob» to adjust the buttonhole slit
width as desired.
115
1017815.0.04_2016-05_Manual_B765_EN