Attaching The Hoop; Overview Embroidery Functions - Bernina 770 QE Manual

Embroidering preparation

Attaching the hoop

> Raise the needle.
> Raise the embroidery foot.
> Hold the hoop with the right side of the fabric up with the attaching mechanism to the left.
> Position the hoop under the embroidery foot.
> Press both attaching mechanisms (1) of the hoop towards each other.
> Position the embroidery hoop (2) above the bracket of the embroidery arm.
> Press the hoop down until it clicks in position.
> Release the attaching mechanism (1).
> Press the attaching mechanisms of the hoop towards each other to remove the hoop.
> Remove the hoop.

Overview Embroidery functions

1
2
3
150
2
1
1
Centering the embroidery hoop to the needle 4
Moving the hoop to the back
Moving the module for the sewing mode
1
2
3
4
5
Grid on/off
5 Motif center
6 Virtual Positioning (is visible while scrolling)