Networking Settings - Toshiba Magnia SG20 User Manual

Manually configuring clients with Windows NT 4.0, Windows 2000 and Windows XP operating systems

Networking settings

Once you have a properly installed network adapter card, you need to make additional
network settings so that the client computer can communicate with the Magnia SG20.
You may need your Windows
NOTE: With the Windows NT, Windows 2000, and Windows XP operating systems,
if a network adapter was previously properly installed and was subsequently
removed, you may believe that the network adapter card is working, when in fact it
is not present. If you complete the steps to establish your network settings, and
these continue to fail, verify that the network adapter card is still physically installed
in the client computer.
Determining network settings
To determine your client computer network settings:
1 Click Start, then select Programs.
2 For the Windows NT
For the Windows
Command Prompt.
3 When the Command Prompt window opens, type
If the words "Request timed out" or "Bad command or file name" appear in the
window, you must configure your network settings.
4 While the Command Prompt is open, type
If the words "DHCP Server.....:192.168.1.1" do not appear, or the words "Bad
command or file name" appear, you must configure your network settings.
5 Click Start, Settings, Control Panel, and double-click the Network icon.
The Network Properties dialog box appears.
6 Click the Protocol tab.
Installing TCP/IP
If there is no listing for TCP/IP in the Network Protocols box, continue with these steps to
install TCP/IP.
1 Click Add.
2 When the Select Network Component Type dialog box appears, select TCP/IP
Protocol in the Network Protocol box, then click Add.
®
operating system setup disk to complete this process.
®
operating system, click Command Prompt.
®
2000 operating system, select Accessories, then click
ping 192.168.1.1
and press
ipconfig \all Enter
298
and press .
Enter
.